Cove — add softener salt
Cove's own use-and-care guide shows this message when the built-in water softener's salt is low, and describes filling the compartment with water on first use and adding salt on refills after that.
Mon–Sat, 8am–8pm
- Reminders, not failures
- No service needed
- Source: Cove
Book a visit
Three short steps, about a minute.
or call (844) 879-5178
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Add salt. Press Enter once added, or press Cancel to ignore.
actually means.
Cove's own use-and-care guide shows this message when the built-in water softener's salt is low, and describes filling the compartment with water on first use and adding salt on refills after that.
Cove home appliance display
What to do when Add salt. Press Enter once added, or press Cancel to ignore. shows on the home applianceKind of codeReminders, not failures
Nothing has broken; the appliance has been counting hours, cycles or gallons and is asking for its routine care. A refrigerator lights a filter icon after about six months of water, a front-load washer suggests a tub-clean cycle after a set number of loads, a steam oven or a dishwasher asks for descaling or rinse aid, and some dryers remind you to check the exhaust. Do the task the reminder names, reset it the way the manual describes, and write the date in the service record.
Usually leads toNo service
Pull the lower rack forward and, if needed, turn the lower spray arm away to reach the compartment cover.
Shows up asDishes Coming Out Gritty or Spotted: Filter, Spray Arms and Rinse Aid
Dishes coming out gritty are plates and glasses with sandy specks, dried food, a white film or spots after a full cycle, often worse on the upper rack or in one corner.
MakeCove
Cove makes only dishwashers, so a Cove visit is all dish care: filters and spray arms cleaned, the door gasket checked and the water supply and drain inspected.
SourceCove dishwasher use and care guide
Confirmed in Cove's dishwasher use and care guide.
Before you book,
in this order.
Each step comes from Cove's own guidance for Add salt. Press Enter once added, or press Cancel to ignore. on its home appliances. Follow it to the end: the last card says whether this is a visit.
Pull the lower rack forward and, if needed, turn the lower spray arm away to reach the compartment cover.
Add softener salt to the compartment, then clean any excess salt from the threads before closing the cover.
Touch Start and close the door to allow the regeneration process to run.
Cleared?
The reminder is gone from the display, the filter, the screen or the tub has been cleaned or swapped, and the appliance runs a full cycle without calling for it again. A clean-filter light or a descale prompt that returns in days rather than months usually means the part it watches is fouling faster than normal, so mention that when you book.
What not to do
This message is not a report that the softener has failed; Cove's own guide treats it as a routine refill prompt. It only becomes a repair question if the softener stops regenerating with the compartment properly filled.
What you may
notice with it.
The home appliance problems Add salt. Press Enter once added, or press Cancel to ignore. tends to arrive with. Answer these at the home appliance before anyone is booked.
All problems
No service indicated
Nothing to service.
Nothing has broken; the appliance has been counting hours, cycles or gallons and is asking for its routine care. A refrigerator lights a filter icon after about six months of water, a front-load washer suggests a tub-clean cycle after a set number of loads, a steam oven or a dishwasher asks for descaling or rinse aid, and some dryers remind you to check the exhaust. Do the task the reminder names, reset it the way the manual describes, and write the date in the service record.
Cove
home appliances.
Cove makes only dishwashers, so a Cove visit is all dish care: filters and spray arms cleaned, the door gasket checked and the water supply and drain inspected.
Cove home appliance maintenanceMore Cove codes
Reminders, not failures on other makes
In Cove's own words
When softener salt is low, “Add salt. Press Enter once added, or press Cancel to ignore.” appears on the display.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Confirmed in Cove's dishwasher use and care guide.
Cove Add salt. Press Enter once added, or press Cancel to ignore. home appliance maintenance,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Add salt. Press Enter once added, or press Cancel to ignore..
Can I clear Add salt. Press Enter once added, or press Cancel to ignore. myself?
Do I need to add water with every salt refill?
What happens during the regeneration process?
Is low salt the same problem as spotty dishes from rinse aid?
Back to your everyday
Still showing Add salt. Press Enter once added, or press Cancel to ignore.?
A booking goes further when it has the reminder or code as shown, the model number from the rating plate, and a word on when that filter, screen or tub was last cleaned. With those three, the office can pack the right filter or cleaner for your appliance.