JennAir Replace Filter: the unit or column water filter is due
JennAir's refrigerators and refrigerator columns show "Filter," "Replace Filter," or a light that changes color as the water filter approaches due, and the status has to be reset separately from installing the new filter.
Mon–Sat, 8am–8pm
- Filters
- Water filter and descaling service
- Source: JennAir
Book a visit
Three short steps, about a minute.
or call (844) 879-5178
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Replace Filter
actually means.
JennAir's refrigerators and refrigerator columns show "Filter," "Replace Filter," or a light that changes color as the water filter approaches due, and the status has to be reset separately from installing the new filter.
JennAir home appliance display · also shown as Filter
What to do when Replace Filter shows on the home applianceKind of codeFilters
A filter has reached the end of its life or is clogged enough for the appliance to notice: a refrigerator water cartridge past its gallons or months, a hood's grease or charcoal filter loaded with residue, a dish-care filter packed with food, a washer inlet filter choked with grit. The fix is a clean or a new filter of the right part number, fitted with the appliance unplugged and the water closed where there is one, then the reminder reset.
Usually leads toWater filter and descaling service
Fresh filters in dispensers and ice makers, and scale cleared from steam ovens, ice makers and dish care machines.
Shows up asAppliance Maintenance Code or Reminder Light: Filter, Descale, Vent Check
An appliance maintenance code is a reminder, icon or short code on a display asking for a filter change, descaling, a tub clean, rinse aid or an exhaust check rather than reporting a broken part.
MakeJennAir
JennAir kitchens are largely built in, so the visit pays special attention to column refrigeration grilles, downdraft and hood filters, and panel-ready dishwashers.
SourceJennAir support: How to Reset the Water Filter Status Light
JennAir uses the same handful of reset gestures across its refrigeration controls as its sibling brands; the exact steps depend on the control panel fitted to the specific column or full-size refrigerator.
Before you book,
in this order.
Each step comes from JennAir's own guidance for Replace Filter on its home appliances. Follow it to the end: the last card says whether this is a visit.
Replace the filter with a genuine part matched to the exact refrigerator or column model.
Reset the status with the gesture that matches your control panel — a dedicated Filter Reset button, a Max Cool/Max Ice hold, or an Options-menu sequence.
Dispense several cups of water afterward to clear air introduced by the new filter.
If the status stays on after the matching reset gesture, book a visit rather than repeat the reset.
Still there?
It usually turns into water filter and descaling service. Book with the code and the model number.
What not to do
This is a scheduled reminder, not a leak or an installation problem. A filter that will not seat properly, or one that is cracked or dripping at the housing, is a separate problem from a routine status alert.
What you may
notice with it.
The home appliance problems Replace Filter tends to arrive with. Answer these at the home appliance before anyone is booked.
All problems
Where Replace Filter usually leads
Water filter and descaling service.
JennAir
home appliances.
JennAir kitchens are largely built in, so the visit pays special attention to column refrigeration grilles, downdraft and hood filters, and panel-ready dishwashers.
JennAir home appliance maintenanceMore JennAir codes
Filters on other makes
Cold storage
Upkeep for everything in the house that keeps things cold: refrigerators, freezers, wine and beverage units and ice makers, cleaned and checked before they start struggling.
Cooking appliances
Upkeep for ovens, ranges, cooktops, hoods, microwaves, steam and speed ovens: burners and igniters cleaned, gas joints checked, grease filters and descaling done on time.
Dish care
Upkeep for dishwashers and disposers: filters rinsed, spray arms cleared, the door seal and drain loop checked, and hard-water scale kept off the parts that heat and spray.
In JennAir's own words
the water filter icon returns to its BLUE color, and the words "Replace Filter" disappear from the display
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. JennAir uses the same handful of reset gestures across its refrigeration controls as its sibling brands; the exact steps depend on the control panel fitted to the specific column or full-size refrigerator.
JennAir Replace Filter home appliance maintenance,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Replace Filter.
Can I clear Replace Filter myself?
Do JennAir columns reset their water filter status the same way as a standard unit?
My JennAir column still shows Replace Filter after I installed a new one — what am I missing?
Should I purge the water line after resetting the filter status on my JennAir unit?
Back to your everyday
Still showing Replace Filter?
A booking goes further when it has the reminder or code as shown, the model number from the rating plate, and a word on when that filter, screen or tub was last cleaned. With those three, the office can pack the right filter or cleaner for your appliance.