The lit control strip of a home front-load washer in a tidy laundry room, a small icon glowing on the display with no characters readable, the washer's door closed and nobody at the machine.

Viking clear-ice unit alternating CL and ICE: a cleaning cycle is due

The clear-ice control counts finished ice cycles rather than reading how much scale has actually formed on the evaporator plate, so the CL/ICE swap arrives on the same rough schedule no matter how hard the water is.

(844) 879-5178

Mon–Sat, 8am–8pm

  • Reminders, not failures
  • No service needed
  • Source: Viking

Book a visit

Three short steps, about a minute.

or call (844) 879-5178

What CL / ICE alternating
actually means.

The clear-ice control counts finished ice cycles rather than reading how much scale has actually formed on the evaporator plate, so the CL/ICE swap arrives on the same rough schedule no matter how hard the water is. Ice keeps coming out while the display alternates.

Viking home appliance display · also shown as CL, CLEAN

What to do when CL / ICE alternating shows on the home appliance

Before you book,
in this order.

Each step comes from Viking's own guidance for CL / ICE alternating on its home appliances. Follow it to the end: the last card says whether this is a visit.

01

Switch the unit off with its On/Off icon until the display reads OFF, then empty the ice bin.

02

Start the built-in clean cycle and pour the cleaning solution slowly onto the evaporator plate as directed.

03

Let the roughly 45-minute cycle finish, check the plate for leftover buildup, and run it again if any remains.

04

Book a visit if CL/ICE returns immediately after a completed cycle.

Cleared?

The reminder is gone from the display, the filter, the screen or the tub has been cleaned or swapped, and the appliance runs a full cycle without calling for it again. A clean-filter light or a descale prompt that returns in days rather than months usually means the part it watches is fouling faster than normal, so mention that when you book.

What not to do

The alternating display is a cleaning cue, not a stoppage; production continues until the cycle is actually started. A blank, dark display is a different condition, tied to a drain-pump safety cutoff rather than a cleaning schedule.

No service indicated

Nothing to service.

Nothing has broken; the appliance has been counting hours, cycles or gallons and is asking for its routine care. A refrigerator lights a filter icon after about six months of water, a front-load washer suggests a tub-clean cycle after a set number of loads, a steam oven or a dishwasher asks for descaling or rinse aid, and some dryers remind you to check the exhaust. Do the task the reminder names, reset it the way the manual describes, and write the date in the service record.

In Viking's own words

While cleaning is needed, UI will alternate between "CL" and "ICE" every 3000 cycles
Viking FIUI5152D professional undercounter ice machine Install / Use & Care manual Viking FIUI5152D professional undercounter ice machine Install / Use & Care manual

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Viking FIUI5152D and FIUI5152DADA clear-ice undercounter machines with the digital display control.

Viking CL / ICE alternating home appliance maintenance,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A family sharing breakfast in a bright, well-kept home kitchen.
For the heart of your home.

Questions
about CL / ICE alternating.

Can I clear CL / ICE alternating myself?
Switch the unit off with its On/Off icon until the display reads OFF, then empty the ice bin. If it comes back, it needs a visit.
Does a Viking clear-ice unit stop making ice when CL/ICE appears?
No, it keeps producing ice through the reminder; the message is simply a nudge that a cleaning cycle is due, not a shutoff.
What triggers the CL/ICE alternating message?
A count of roughly 3,000 completed ice cycles, tracked by the control board regardless of local water hardness.
How long should I expect the Viking clear-ice cleaning cycle to run?
About 45 minutes from start to the point where the plate can be checked for any remaining buildup.

Back to your everyday

Still showing CL / ICE alternating?

A booking goes further when it has the reminder or code as shown, the model number from the rating plate, and a word on when that filter, screen or tub was last cleaned. With those three, the office can pack the right filter or cleaner for your appliance.

(844) 879-5178 Schedule maintenance