ApplianceMaintenance.center (844) 879-5178Mon–Sat, 8am–8pm Book a visit
Close view of a home gas cooktop with its cast iron grates lifted off, one brass burner head exposed with its cap set aside, a technician's hand seen only from the wrist down clearing a port with a thin straight pin, every burner off and no flame, a small spray bottle of leak detector on the counter, soft daylight.

Burner, Igniter and Gas Connection Check

Burner ports and caps cleaned, igniters cleared, every flame read, and the gas connector and shutoff leak-tested.

(844) 879-5178

Mon–Sat, 8am–8pm

  • Low to moderate cost band
  • 5 steps on the visit
  • 3 problems it answers

Book a visit

Three short steps, about a minute.

or call (844) 879-5178

What the burner, igniter and gas connection check
involves.

A gas cooking appliance runs on a simple chain: a shutoff valve at the wall, a flexible connector to the appliance, a regulator, the valves behind each knob, and the burners where gas meets air and a spark. Upkeep on that chain is mostly about keeping the burner end clean and confirming the supply end is tight. Spills that bake into the burner ports turn the flame yellow and uneven; a cap sitting slightly crooked does the same; grease on an igniter's tip makes it click without lighting; a connector pinched behind the appliance or corroded at a nut can seep. This check covers all of it, with the gas on only where testing needs it. The grates and caps come off and the heads are cleaned, with the ports cleared by a straight pin or a wire made for the job rather than a toothpick that can snap off inside. Igniters are wiped dry, each burner is lit and its flame read at low and high, and the oven or broiler burner is watched the same way. The connector is looked over for kinks and age, the shutoff valve is turned to prove it works, and every joint is tested with a leak detector or solution. Anything that shows a leak is closed off and becomes a repair on the spot.

How the visit goes

What it usually costsLow to moderate · Burner heads, ports and caps cleaned, igniters cleared, flames read, gas connector and shutoff leak-tested

A four-burner cooktop with light spills is the light end. A pro-style layout with six or eight burners, a griddle and two ovens takes longer, and an old connector swapped for a new one adds a part.

Answers 3 problemsGas Smell Near the Oven or Burners: Get Out, Then Call

Burner Flame Yellow or Uneven: Ports, Caps and the Air Mix · Hood Fan Weak or Noisy: Grease Filters, Blower Wheel and Duct

Comes up most onCooking appliances

Burner, igniter and gas connection check,
step by step.

Log the flame check and the leak test, and name anything found that is now a repair.

01

Take off the grates and burner caps, and look at each burner head, igniter and the area under it for spills and grease.

02

Clean the heads, clear the ports, dry the igniters, and seat each cap square on its head.

03

Light every burner, including the oven and broiler, and read the flame at low and high for color, shape and steadiness.

04

Check the connector and the shutoff valve behind the appliance, and test every reachable joint with a leak detector.

05

Log the flame check and the leak test, and name anything found that is now a repair.

The problems
it answers.

3 of them, from gas smell near the oven or burners: get out, then call to hood fan weak or noisy: grease filters, blower wheel and duct.

All problems
An empty home kitchen at dusk with a stainless gas cooktop and a wall oven, every burner dark and every knob at off, the kitchen window and the back door both standing open to the evening, a yellow-handled gas shutoff valve visible low in an open cabinet beside the cooktop, seen from the hallway. Fire, gas, water or wiring risk

Gas Smell Near the Oven or Burners: Get Out, Then Call

6 causes, cheapest first

Before you call

Tell us this when you book

  1. Whether the appliance runs on natural gas or propane, and whether it was ever converted
  2. Which burners light slowly, click on, or burn yellow or uneven
  3. Where the gas shutoff valve behind or beside the appliance is, if you know
  4. Whether you have noticed any gas smell, even a faint one, and when

It also answers

Low to moderate,
on the site's scale.

A four-burner cooktop with light spills is the light end. A pro-style layout with six or eight burners, a griddle and two ovens takes longer, and an old connector swapped for a new one adds a part.

Read the full cost guide
ServiceRelative cost
Condenser coil and fan cleaned on a refrigerator, freezer, wine or beverage unit or ice maker, drain pan checked
Water filters replaced and flushed, inlet screens checked, descaling run on a steam oven, ice maker or dish care machine
Door seals tested, cleaned and reseated, hinges and cabinet level adjusted, a worn gasket replaced
Lint path cleaned from the screen housing through the transition duct and wall run to the outside hood
Drain filter cleared, door boot and detergent drawer cleaned, tub clean run, fill hoses checked and machine leveled
Filter and sump cleaned, spray arm nozzles cleared, door seals and dispensers checked, drain loop confirmed
Burner heads, ports and caps cleaned, igniters cleared, flames read, gas connector and shutoff leak-tested low to moderate
Hood or microwave grease filters degreased or replaced, charcoal pads renewed, fan housing wiped, damper checked
Annual plan: scheduled visits across cold storage, cooking, dish care and laundry, with one running service log

Where it
comes up most.

Most bookings: Cooking appliances.

All home appliance types

Often the same visit

A home kitchen with a stainless pro-style gas range and a matching hood above it against a light tile backsplash, the grates lifted off and laid on a folded towel on the counter, a technician seen only from the shoulders down wiping a brass burner cap with a soft cloth, a clean baffle filter leaning beside the towel, all burners off, soft daylight.

Cooking appliances

The makes
we see it on.

35 makes on this site, and the burner, igniter and gas connection check on any of them. Each mark opens that make's own page.

All 35 brands

Burner, igniter and gas connection check,
where we come out.

The home, the climate and the building all change how the burner, igniter and gas connection check goes. These notes are about that, metro by metro.

All service areas

Tampa BayFL · 31 areas

Gas cooking around Tampa Bay often runs on a propane tank as well as utility lines, and a burner, igniter and gas connection check there cleans burner ports, tests igniters and looks over the flexible connector behind the appliance without ever opening a fitting.

OrlandoFL · 30 areas

Many newer Orlando houses came with gas cooking from the builder, and a burner, igniter and gas connection check there clears ports clogged by boil-overs, confirms a steady blue flame and inspects the connector and the valve that closes it off.

Miami / South FloridaFL · 47 areas

Salt air near the South Florida shore corrodes igniter tips and burner caps on gas cooking appliances, and a burner, igniter and gas connection check there cleans them, reads the flame and looks for corrosion along the connector.

New York MetroNY · 75 areas

New York apartment buildings put their gas piping through periodic inspections under city law, and a burner, igniter and gas connection check inside the apartment complements that by cleaning ports, testing igniters and looking over the appliance connector.

HoustonTX · 36 areas

Gas cooking appliances in a Houston home that took on floodwater need a look before they are used again, and a burner, igniter and gas connection check there inspects burners, igniters and connector, while any valve the water reached is handed to a repair visit.

ChicagoIL · 50 areas

Older Chicagoland homes cook on gas more often than not, and a burner, igniter and gas connection check there cleans ports, tests igniters and flags any decades-old uncoated connector for replacement with a newer flexible one.

Los AngelesCA · 95 areas

Los Angeles sits in active earthquake country, and a burner, igniter and gas connection check there cleans ports and igniters and makes sure the appliance's flexible connector has slack and the unit is restrained so a quake does not tug the line.

San DiegoCA · 31 areas

Inland San Diego homes near wildfire country may have their gas shut off during an evacuation, and after the utility has relit service, a burner, igniter and gas connection check confirms that every burner lights cleanly and the connector sat through it unharmed.

San Francisco Bay AreaCA · 74 areas

Bay Area households are asked to know where their gas shutoff sits because of earthquakes, and a burner, igniter and gas connection check there cleans burners, tests igniters, checks the connector's slack and shows the owner the appliance's own shutoff valve.

A family sharing breakfast in a bright, well-kept home kitchen.
For the heart of your home.

Questions about
the burner, igniter and gas connection check.

Is a burner that keeps clicking after it lights a sign of trouble?
Most often it is water or grease on the igniter or a cap that is out of place, both of which are cleaned or reseated on the visit. If it keeps clicking with a dry, clean igniter and a seated cap, the switch or the spark module is checked, which is a repair.
Can a homeowner clear the burner ports between visits?
Yes, with every knob off and the burner cold. Lift off the cap, clear each port with a straight pin, and let the head dry fully before relighting. Avoid toothpicks, which break off inside, and avoid soaking the igniter.
Should a carbon monoxide alarm be near the cooking appliances?
Any home with gas appliances should have carbon monoxide alarms, placed as the alarm maker and local codes describe, usually outside sleeping areas and on every level. A sooty yellow flame is one more reason to have one working.

Back to your everyday

Ready to book the burner, igniter and gas connection check?

Have these to hand: whether the appliance runs on natural gas or propane, and whether it was ever converted, which burners light slowly, click on, or burn yellow or uneven, where the gas shutoff valve behind or beside the appliance is, if you know, whether you have noticed any gas smell, even a faint one, and when.

Schedule maintenance Call (844) 879-5178
(844) 879-5178 Schedule maintenance